Autosport Labs

Here is the other half, what do you think, its a little messy at the moment.
Its mounted on an aluminium plate with anti vibration mounts.

I know this question is as old as jesus himself but i still havent found an answer. Where Oh where can you get New connector pins for the EDIS wiring socket..UK suppliers please. I had a look on the VWP site but they seem to short. http://img442.imageshack.us/img442/2953/edis8connectorha3.jpg I now ...

So is the cable pictured ok to use.?

And i DO need to ground BOTH ends to the SAME point.??

This a picture of the wire i will be using. do you need to earth both ends.??

Hi all, i thought i would update you on the installation on my beetle engine.

i have gone slightly mad.!!!!!!!!!!!!!!!!!!!!!!!!!! OK i feel a little silly. The cable in question is two core but it has a stainless steel braid (shield) instead of the foil. i suppose you could say it looks like a braided brake hose But with a clear plastic/PVC coating on it. I actually use it at...

Hi, is it possible to use wire with an external stainless steel shield or does it need to be the standard type with internal copper shield.

Ahhh i got ya......so it IS just me then.

Can you tell me why the link to this forum is so difficult to find from the home pages.....or is it just me.???

HI, the trigger wheel is painted both sides, i to was a little concerned about the effect of cavitiation/corrsion but the pully wheels is quite cheap and so was the trigger wheel so if it lasts a few years its not realy a great loss just to replace them.

This is how i have now fitted the trigger wheel i have used an aluminium pulley and machined the outer edge for a nice close look.



This wheel is for a T1 aircooled VW.

Iam about to mount the trigger wheel to my pulley, the question is where on the missing tooth should TDC actualy be, at the start of the gap the middle or the end.??

Thanks.

Hi, when fitting the trigger wheel to the pulley is it best to use an aluminium pulley or will the stock steel one be ok,? Iam a bit concerned that the VR sensor will be affected by the steel pulley.
Does there need to be a clearance gap between the steel pulley to avoid any possible interference.

I have an old PC(3 years)(not laptop) in the garage i presume the serial port on that is ok to use.??
I understand i need a serial lead with a male one end.? what about the other end.? i cant just look because the PC is in the loft space and i havent had a chance to get it out.