Search found 6 matches

by Q102
Wed Jul 04, 2007 8:11 pm
Forum: Installation
Topic: Nearly, but not quite - no sparks
Replies: 11
Views: 10019

Try the VR connections the other way round!
My engine was the same - no spark.
I used the weber trigger wheel kit which appeared to plug straight into the EDIS loom but would work until connections swapped at EDIS module end.
by Q102
Sun May 27, 2007 10:12 am
Forum: Ignition Map Library
Topic: maps for xflow
Replies: 2
Views: 8205

Using this map (xflowmap) on my Caterham 7 - alot better than dizzy. Might need a bit of tinkering on part throttle/light load. My car has 1700xflow, 234 cam, twin 40 DCOE carbs, gas flowed, lightened & balanced. Running on Super unleaded (97octane?) Approx 150bhp when last power tested (114bhp ...
by Q102
Thu May 03, 2007 8:36 pm
Forum: Operation
Topic: Rev counter drops to zero ...
Replies: 0
Views: 3189

Rev counter drops to zero ...

Newly installed Megajolt, running latest firmware etc.
Car rev counter drops to zero at above 3500rpm - reads ok on configuration software (laptop in passenger footwell), starts reading ok when revs drop below 3500.
Tacho output taken from mjlj box direct to standard Caterham rev counter.

Any ideas?
by Q102
Mon Apr 30, 2007 8:23 pm
Forum: Installation
Topic: Megajolt will not talk to pc
Replies: 4
Views: 4024

Turns out my Serial lead is a bit dodgy.

Have now successfully downloaded latest version and communicates with pc ok.

Thanks for your help.

Jonathan
by Q102
Mon Apr 30, 2007 3:27 pm
Forum: Installation
Topic: Megajolt will not talk to pc
Replies: 4
Views: 4024

Thanks for the prompt reply.
Using a proper Serial port.
Just tried V3.0.0 config software - connects ok but displayed ignition advance not stable & TPS not moving (stays at full scale)
Why would the controller be a lower version - I only got it from you a month ago?
by Q102
Mon Apr 30, 2007 3:03 pm
Forum: Installation
Topic: Megajolt will not talk to pc
Replies: 4
Views: 4024

Megajolt will not talk to pc

Hello everybody Got my Megajolt installed ok. V3.0.0 pcb Downloaded latest config software. Car starts in "Limp home" mode. Tried to connect my laptop - using serial port - got message "Unsupported controller version" Tried to download firmware - get message: "waiting for HC...