Autosport Labs

Is there anyone in the Benfleet area in Essex who can help with my 'Mapping' and general set-up etc?!?!? I'm a real novice at this!! I've never attempted this sort of ignition set-up before and have a lot to learn!!! I bought my MJL on eBay and have version V.3.0.0. I'm running a 2.0l zetec silverto...

I'm a bit of a newbie to this so here goes. The RS232 lead supplied with my Megajolt has a male/female ends with 9 pins/holes. My laptop though doesn't have an RS232 male or female port, only the 15 pin port for a monitor. Is there another lead i can buy with a 9 pin male end and an alternative end ...

Thanks for your reply. I'll have a look at the 'how to' section and should hopefully help with my queries. My concern at the moment is if i load the MAP i have and car runs well, timing advances when i rev the engine but there is a flat spot mid revs or the carbs are popping and farting and missing ...

Hi everyone! I'm new to this site and to Megajolt. I'm about to start building my forth lotus 7 style kitcar, all of which have been pinto based in the past. On this project i'm going down the 2.0l zetec (silvertop) route. I'm planning to run the zetec with zzr1100 carbs. I've been in discussion wit...