Autosport Labs

I don't have access to an o-scope.I just toned out my wires with a volt meter and found something interesting.With the plug disconected from the edis and mjlj when I connect to the pip connection at the edis end of my harness I get a tone on 5 different wires at the mjlj end.??????If nothing is conn...

I am having problems with my mjlj.My timnig does not advance.On my runtime display my rpm's don't change no matter what the engine is doing,but the boost levels on the display change with the engine.If I hook up a timing light there is no change at all in the timing.I believe the mjlj and my compute...

I forgot to mention,I started the car without the mjlj and it wont go to much above idle without "stumbling" is it possible that maybe my laptop just isn't showing the rpm's?With the mjlj module connected it is pretty smoth throghout the rpm range although I haven't realy stood on it yet.

I have proper power to everything.The diodes might be backwards.Looking at the board with the molex plug on the right and the map sensor towards the bottom the colored stripes on the diodes are(left to right)tan,black,red and gold.R10,R2,R6,R8,R4,R5,R11,R9,R7.

I finaly got my car running but when I pull up my runtime display the rpm's show 2197483647.I can change the values on the timming map and reflash,but nothing seems to change.I put all new 2n2222a's in the board and tried it again,same thing.What would cause this to happen? I'm stumped and can't tu...

I looked at the picture again and the R diodes look like they might be backwards but I'm not sure.The picture seems to show the red stripe to the left of the black one in the center.Mine are on the right side of the black stripe

I finaly got my car running but when I pull up my runtime display the rpm's show 2197483647.I can change the values on the timming map and reflash,but nothing seems to change.I put all new 2n2222a's in the board and tried it again,same thing.What would cause this to happen? I'm stumped and can't tun...

Nope,didn't work.

I assenbled my mega jolt and instaled it into my car.But when I pull up my runtime display it shows the rpm's as 2197483647.The only issue I can see is that when I assembled it I did not have the 2n2222a transister and used one from radio shack that says it is a mps2222a.Is this my problem or is the...

I have been checking the info in my service manual and it says that the hall efect unit has two power feeds and one nutral.Does anyone think it would work if I conected these wires to the vrs sensor and if so do I need the two power wires or one or just the nutral?

I have assembled and tested my mega jolt it all is good.My question is i'm going to be useing it in a volkswagon with the stock fuel injection(hopefully not for long)since the injectors are trigered from the hall sender does anybody know how I would make this work?

Thankyou just makeing sure I have it right

Now that i'm ready to install my mjlight I would like to ask a couple of questions. 1st- When I mount the edis module and coil,do they need to be grounded if I put them onto an aluminum mounting bracket? 2nd- How are you guys attaching the vr sensor to your motor?Home made brackets I would assume,bu...

I get how to mount it all but I would like to know if the crank sensor needs to be adjustable for setting timming for any reason,like a distributor is or do you just mount it solid?

I have downloaded java to my pc and when I try to run the program I get an error stating that I am missing launch file jnlp.Has anyone had or heard of this problem?What should I do?I have allready loaded java three times with the same results