Search found 7 matches

by Jawa2112
Mon Oct 04, 2010 12:35 pm
Forum: Installation
Topic: odd weak spark problem...???!!!
Replies: 12
Views: 15107

yea thats it, one weak and one strong on each bank. there has to be something im missing because it dosent seem to follow the coil towers or wires, it follows the cylinder which seems impossible. Ive now swapped the entire wire set with junkyard wires, idle actually got worse "on the dead cylin...
by Jawa2112
Mon Oct 04, 2010 11:53 am
Forum: General Discussion
Topic: Build it yourself kit? Wheres it gone?
Replies: 11
Views: 21005

For what its worth i agree with Tom. I will admit my skillset is above average in regards to soldering "i work with fine pitch and ultrafinepitch every day" However I enjoyed the DIY aspect of Megajolt, including the assemby, and i imagine there is probably a number of people who enjoy tha...
by Jawa2112
Sun Oct 03, 2010 3:09 am
Forum: Installation
Topic: odd weak spark problem...???!!!
Replies: 12
Views: 15107

odd weak spark problem...???!!!

Ok i have a spark problem i cant rationalize... I have and EDIS4 setup, ive been troubleshooting a misfire/cutout at 4500RPM that i have had all summer and im not sure if its related to this problem although i wouldent be suprised. I have an aircooled VW type 1 engine installation and have cylinders...
by Jawa2112
Thu Apr 22, 2010 4:57 pm
Forum: Installation
Topic: Is this VR signal useable?
Replies: 8
Views: 8539

I hope to get the pulley cut true, but i think to do that i would need to have it mounted to a crankshaft and spinning the entire assembly to have it proper wouldent I? When I took these pictures of the missing tooth area i more critically analyzed the mark left on the teeth from when the sensor con...
by Jawa2112
Tue Apr 20, 2010 4:20 pm
Forum: Installation
Topic: Is this VR signal useable?
Replies: 8
Views: 8539

The sensor is right up against the block and there is no space behind the pulley, i have included pictures "that were shamelessly borrowed from another site" My setup is identical to these pics, the sensor cannot be moved to look at the tips of the teeth, The engine is a High performance T...
by Jawa2112
Tue Apr 20, 2010 2:23 pm
Forum: Installation
Topic: Is this VR signal useable?
Replies: 8
Views: 8539

The pulley is aluminum, the wheel and the screws are both steel I had considered the idea the sensor is picking up the screw heads but i don't believe thats the problem because there dosen't seem to be 6 evenly spaced places of higher or lower amplitude. I had also thought that the steel screws woul...
by Jawa2112
Tue Apr 20, 2010 3:54 am
Forum: Installation
Topic: Is this VR signal useable?
Replies: 8
Views: 8539

Is this VR signal useable?

Hello all this is my first Megajolt install, hoping for some advice. the VR signal in these pics comes right from the VR sensor while the engine is idling at 800RPM "using the distributor" I have included a picture of the trigger wheel its mounted to the back of a pulley and its an inside ...