Autosport Labs

I'm in the same boat, trigger wheels used to sell coil pack connectors but they've changed there website in the last few weeks and no longer list them. I was looking at VWP's website and I was wandering if the 3 pole connector will work: http://wwww.vehicle-wiring-products.co.uk/VWPweb2000/connector...

Earlier in the Year I tried to map my car on the rollers but had a few difficulties caused by my lack of understanding of MJ (I've running a VS2 PCB with the lastest VS2 firmware & configurer software VS 3.2.1) Can I change the RPM & load bins whilst the car is running? When you change a val...

I've connected my MJ up to the ignition so that it is only powered when the engine is running, as I don't like the idea of it being on 24 hours a day. However this proved to be a real pain when I had the car on the rollers as it meant I couldn't make any changes to the MAP when the engine was off wh...

On EDIS 4 is pin 10 for cylinders 1 & 4 and pin 12 for cylinders 2 & 3? or is it the other way round?

Cheers

Rob

Brent, I sourced the parts separately (including etching the PCB) the chip came from Farnell, so it has absolutely nothing on it. I've down loaded the boot loader software and tryed it on a couple of computers (wasn't sure if it was my serial to USB adaptor that was causing the problem, so tried an ...

I've almost got my second MJLJ vs.2 up and running, but I can't seem to get the boot loader onto the chip, what hardware do people use to do this? I've tried using but my MJ (which I've tested using the chip from my first MJ & it works fine) and I've tried using a pic programmer I picked up on e...