Autosport Labs

I installed this last summer and it has been working flawlessly. I have minimal fabricating skills and was able to do this in about 2 hours. I made my own 36-1 trigger wheel out of my 3 grove crank pulley. Since the back groove is not used in my setup, I turned the back of the pulley into my trigger...

Tried sucking and blowing on the tube to no avail already.

The KPa gauge reads 100 (wot) at all times.

I will have to check for errors again, but I am pretty sure there are none.
RPM signal is good.
Software works like it should.
Truck runs better than ever, just no MAP.

Nope. Its a pre-assembled one.

I just got my setup running on my Chevy small block powered '84 s10 blazer. The MAP sensor is hooked up but doesn't give a read out. Its working like a mechanical advance dizzy at the moment. I can't find any other MAP settings besides the one option in the configurator Options. My vacuum seems abun...