Autosport Labs

Ok so I had to advance the trigger offset by +2 degree it has fixed it.

The torque is unreal. Why did I have to go + 2 if I go -2 it bogs down?

so i just changed it to the md286 map & it has improved the low done a fair bit & almost rid the problem im having.

as far as timing go's is that correct??

HI everyone! so i have my mega jolt running well now & has not missed a beat :) so much better then a dizzy :D i have a few questions- problems running the 1380 map. i have checked the timing in limp mode where it is locked to 10 degree's & on my crank i got 6 deegre thats the 3rd tooth down...

thanks brent yes they have turnt into the same thing lol

it has a brake booster port.

i will get a brass valve & tee it off from the mega jolt!

will it be ok to drive the car as is on mega jolt for now until i can T it off? or should i go back to the dizzy?

yes it has a brake booster port.

i will get a brass valve & tee it off from the mega jolt

problem sorted!

will it be ok to drive the car as is on mega jolt for now until i can T it off? or should i go back to the dizzy?

it is Map. it runs fine in limp mode also. it's running fine was a faulty edis. i have it connected to the twin su vacum take off, when i start the engine & it is just on idle it is showing load of 100 so when i rev it or drive the car the revs move up **green little Box** & the load is less...

it is Map. it runs fine in limp mode also. it's running fine was a faulty edis. i have it connected to the twin su vacum take off, when i start the engine & it is just on idle it is showing load of 100 so when i rev it or drive the car the revs move up **green little Box** & the load is less...

if you look closely mines running the opposite way?

what would cause that?

below it runs the correct way i assume?

http://www.youtube.com/v/sUg32C4qRPc?


if i changed the wires around on the sensor on the trigger wheel would that fix it?
help please!

right the meg jolt is working bloody smooth. impressive!! another faulty edis unit from ebay. this time i got one form a wreckers seems to work perfect. my next question is it is still ascending on the software is this normal? any reason? are my sensor wires reversed? please check the youtube video ...

right i got it working! thank god. faulty edis & sensor did not seem to be sitting right. I got my mega jolt working but I suspect something is not right or one wire is switched?? one thing is odd and im not sure what is going on, it is showing load & revs from the bottom instead of the top....

right i got it working! thank god. faulty edis & sensor did not seem to be sitting right. one thing is odd & maybe i have wired the plug/sensor wrong? it is showing load & revs from the bottom instead of the top. what i see on youtube it starts from the top & works it's way down? so ...

I can confirm the megajolt talks to the computer I Can you see variables (rpm, MAP advances) change on the computer screen I can even run and save a diagnostic read out and use the tuning graph.

I will go over everything you mentioned. Tomorrow

hi everyone! im trying to mega jolt my 1293 so i have bought a mega jolt! :D i bought a pre done wire harness for it for a mini & a trigger wheel kit for a mini. i can't get it to work. firstly ill start to tell you what i have done & what i have not. firstly it will not start in limp mode. ...