Autosport Labs

Hi, thanks for your help.
Cornelius

here is the picture

Hi, many, many years ago, I bought a Hard Rev Limiter V 1.2.0. I am about to put it in my only recently purchased MegaJolt. I have read the instructions and I understand that I have to solder 4 wires. Must I soder anything else ? There are still 3 empty holes, marked C, B and E I guess that it is a ...

@ Oliver

I had a look at the site you mentioned.
There are 4 different products.
Which one have you bought and used ?

This is not from me, but
I saw some photos here:
www.lathyrus.eu

than click on:
Special tools and parts

than click on:
Knock detection circuit

Hi,

here is a picture with my installation.
Rover V 8 3.5 in a Triumph TR 7.
I swapped the HT cables until it locked tidy.
As said before, you can swap cables on EACH coil,
not between the coils.

Cornelius

Thanks, Brent

Cornelius

Hi, I have a MegaJolt V3 and I'm about to put it in my car. EDIS is running already in Limp Home mode. I have some questions about flashing. I have found this and I quote from the Operation guide: "Persisting the data to flash requires a significant amount of time" 1. Is there a message wh...

« I don't like to use any more terminals and connectors than absolutely necessary« I totally agree with your statement. I just could leave two slots for the fuses empty. Are the wires all on one side of the parallel crimp splice ? I am confused about crimping and soldering. I am used to crimp or so...

One reason is, I have this nice little holder for the relay. The other reason is, I can distribute easily the power from one point to the four devices. Two coil packs, EDIS module, and MegaJoltBox. How do you connect four wires to one wire ? For earth distribution I will use this: I got this from a ...

I'm about to put the MegaJolt EDIS into my car.
I have planned to put some fuses and a relay in.
What values of fuses should I use ?
Please have look at my sketch.

I don't use any USB-Serial Adapter, so no problems there.
Than I wired a switch in the power supply.
That made all the difference.
It worked!
Thanks again Brent.

Cornelius

Hi Brent, thanks for your answer. Sorry I can't report a success. I followed the steps in the firmware upgrade guide. I got the "Waiting for...." message and than: "received 0xfc (good)" After powering up the unit I got: "Calibration break pulse sent. Count:1 Can't read MCU ...

Hi, I have read this forum a couple of hours. Found an answer somewhere else, saying: you should download V 3.2.1 I did it and connected the MJLJ board. I got a message that this version does not work with my firmeware. So I downloaded and installed version 3.0.0 Now I got the "Could not open p...

Hi Ryan,

thanks for your answer.
I found the following versions:
V3.0.0
V3.1.0
V3.1.1
V3.1.2
V3.2.0
V3.2.1
V3.3.0
V3.3.1
V3.3.2

Which version should I download onto my computer ?

Cornelius