Autosport Labs

I've tried to make some pics of mt wiring but I doubt that someone who will see what go where ... lol http://img207.imageshack.us/img207/5486/img20120530173647.jpg http://img411.imageshack.us/img411/3086/img20120530173558e.jpg http://img29.imageshack.us/img29/747/img20120530173453.jpg http://img16.i...

I'm going to test again with voltmeter and a friend... I also will try to take some pics of my wiring.
Find someone in France who have installed an EDIS is not easy.
Keep you informed...

I've change my battery and it's still the same...
I dont have made all verification of voltage in different wire but I admit that I'm a bit fed'up with my carb installation...
I'm realy thinking about bodies setup now..

I have remove the MJLT and and jump the coil power to +12v. The engine don't start. I've check my wiring everything is good, I have +12V to MJLT and EDIS when contact is on. When starter motor is ON, I have +9V to MJLT and EDIS. I suspect a low battery so tomorow I'll recharge the battery and test i...

Thanks for help Brent. I've tried to inverse vr sensor wiring and it's the same. I've make some vérification of signal. Vr sensor seems to be ok Saw signal seems ok. Tach out also. But pip signal is not normal: Between edis pin1 and ground 0v when not running. But i should have 12v.... I've measured...

Here is my problem. First of all I verify 3 times my wiring and everything seam to be good. (just a precision : my MJLJ and EDIS have a permanent +12v that I stop with my battery cut off) So my configuration is with the EDIS4 and MJLJ V4 with MAP configuration and a good computer/MJLJ connection Whe...

No I don't but I really want to start with an "adapted" map cause my skills in tuning ignition is very low...

As title, I'm searching for a map from a standard or lightly tuned gti6 engine (XU10J4RS).
My configuration is MJLJ V4 with MAP sensor. My car have dellorto DHLA 45 carbs.

Many Thx if someone find me that.

Ben