Autosport Labs

Update.

spent an afternoon trying to find a EDIS. found one and fitted it to the car. went for a test - same problem...

put the 2nd hand coil on, and the problem seems to have gone! (fingers crossed11)

thanks for the input..

Danny

cng1 wrote:Don't worry about wiring the megajolt through the cut-out, just the power to the coilpack (central pin).

thanks..

will do.

I have just realised that when i pull my isolator switch whilst the engine is running the engine continues to run. What is the best way to wire the MJ through the switch?

danny

whats the weather been like where you are??? Dampness somewhere??? Is the mjlj in an area that could be open to the elements?? the weather and the car have been dry. car has been behaving this weekend - this drives me mad ( when will it re-appear!) got a coil but no luck as yet with the edis.. than...

I would also double check your wiring, especially looking at the grounds and make sure they have good clean contacts and solid solder joints with no frayed wires. Just as an idea :wink: will do - - thanks. I'm tracking down spares (coil and edis) I ran it yesterday afternoon and it ran badly and pa...

Hello, Look at the EDIS module first- a wholesale cut of power would indicate the EDIS is not firing the plugs at all. So- check your VR sensor, coil pack connections, power and ground to the EDIS module. A Megajolt failure would manifest itself more as a loss of power, but still a running engine: ...

I have a v2 with throttle pot which I have had fitted for the last 5 years or so. there has been a occasional fault - quick history:- 3 yrs ago on a sprint , twice at the start ( whilst giving it full beans at about 5000) the engine totally cut out. I turned the ignition off and rolled to a halt. th...

Thanks all, got it going with updated firmware, using USB adaptor.

Now i need to find out about rolling road tuning live!


Danny

thanks, but which ones will work? Where do I find the software by 4600cc?


thanks

I'm wanting to make some changes to my megajolt which i fitted some time ago. I dont have any software as i have changed laptops. a few questions...

how do i check what firmware it loaded?

how do i load the latest firmware if i need to ?

what software will i need?

thanks

danny cusworth

I would like to have my a series engined mg midget set up MJLJR /kent 296/weber 45dcoe.

can anyone recomend a rolling road nearby with expierence with megajolt jr?

i am in wilmslow, cheshire, south manchester.

Looking forward to this! will by very useful when sprinting to see any improvment (or not!) corner by corner.

keep up the good work.

danny

I have today connected the new sofware to my V2 board. Its great and a major step forward (thanks Brent)

I have a question. How do you save the data log so you can view at a later date?

Thanks

Danny

i can believe a discrepancy of 1 - 4 deg, but not 10. with a map running advance of 30 deg and cranking at 5 deg surly i would be the first to know if somthing is amis? therefore it must be the lamp which is counting each spark and doubleing the advance ?? i do agree - i am amazed that no one has ha...