Autosport Labs

Aside from the latest firmware, what was the outcome on this? Setttings for a 6 cylinder?

After you create an account, it will be under events on: http://www.race-capture.com/

I updated my firmware to the latest and the issued cleared. Now it will 'write' completely.

Which firmware do you have on yours?

Running into a similar issue. Had the USB to Serial deriver working. Loaded the bootloader to re-flash the unit. Now it won't show up as a 'port'. Did the 'uninstall' and on the second try, it unloaded and found the correct driver again.

Everything is working fine after that.

I just ran into the same issue...troubleshooting now

brentp wrote:Yes! The top two current projects are the bluetooth modue + android app, plus a CAN interface via the hardware expansion port. Watch for news on this within the next few weeks!

Need an iOS app version. Any programers willing to port the Android work over to iOS?

Welcome Ian!

I have had issues with Innovate reading a little low with their LC1 package. I did a somewhat similar test with actual measured vs Innovate vs AEM's and found the the actual and AEM read the same and Innovate a little low. Not sure that helps, but does confirm that Innovate does read low sometimes.

What was the resistance values and what did you use for the pull down?

Will this support MetroPCS? They maybe the cheapest monthly service rate...

brentp wrote: Any idea on the connector?

Not sure on the connector. Not sure where to get that one.

Future reference, you can get all the wiring diagrams for BMW's here:

http://www.bmw-planet.com/diagrams/

Pretty handy site.

I posted the pin out on the FB post, but here is the actual diagram from the book. Looks like only pins 1,4, and 5 are used. Leads on 1 and 5 with the wiper arm on 4. Not sure the values.

sbarton wrote:Hey Brian,
Can you give me the scaling values for fuel and coolant on your E30?

-Scott

Yes, about to do an install on an E30 - that would most helpful!

Warning : This negative lead connected to the ignition coil has a 500v voltage spike that RaceCapture/Pro isn't designed to handle. ... We are working to release a small adapter board that can safely interface this coil signal to RaceCapture/Pro's pulse input. The technical information can be found...