Autosport Labs

OK, I have tried the unit multiple times again. The OBD data worked on my car throughout at day at a test and tune through multiple power cycles. The next time I tried was at Spring Nationals and it did not work on my car once over a four day period. On the last day I tried it on my car to verify OB...

Thanks for the quick response Brent, and for returning my call. To answer your questions: The OBD data side of things has worked/not worked intermittently for some time but you are correct that is was working the last time I tried it and it once again is not working. No settings have been changed be...

So I tried using the RCP2 today and the OBD data was not functioning as previously experienced so I looked at some logs as you suggested. What I saw was that it reported the CAN connection initializing successfully but then when I would select "debug" it displayed this message over and ove...

So I pulled the unit from my car and tried it on a neighbors car, also a 2013 FR-S (it was available on short notice). It worked as it should. I immediately tried it on my car and it also worked...oh the joys of troubleshooting an intermittent issues! I guess I will have to try on a different make/m...

Well, the saga continues... In preparation for an event tomorrow I went to check the setup and once again no OBD/Can data is being registered in the RCP2 unit. GPS and accelerometer data still seem to be working. I tried power cycling the unit and vehicle multiple times with no success and checked t...

The modification to the can bus termination seems to have fixed the issue. I am looking forward to trying the setup out this weekend to confirm the issue is completely resolved. I also set up the can bus mapping for brake pressure and steering angle and am super excited to see this data. Thanks for ...

Hi Brian, Ok - that helps quite a bit. The Scion / FRS is one of the few cars out there that does not like seeing CAN bus termination at the far end of the CAN bus connection (on RCP's side). RaceCapture/Pro MK2 has fixed CAN bus termination that can be disabled by removing the termination resistor...

Hi Brian, thanks for starting this new thread. First question, did OBDII ever work, and what year/make/model is the car? I'm homing in on the ECUs CAN bus faults - trying to understand if this is an emerging issue, or was there all along. It's true, RaceCapture/Pro MK2 has the 12v power connections...

I've been experiencing a problem with OBD2 data as well and suspect I may have a bad cable. When I first received my RC Pro2 last summer-ish, it did not receive power AT ALL through the OBD2 cable so I wired in a 12v source from the fuse box. After a couple of autocross events all the sudden power s...

Edit: New thread started in hardware forum