Autosport Labs

Tried splitting signal between megasquirt and megajolt and does not work. Car starts with just PIP signal and no megajolt attached. However, when the megajolt is attached, it does not start.

Hey guys i really need some help on this. If i cant get this to work im gonna go with a MSnS setup.

Hey, i was wondering what some of the reasons could be for the MJLJ to not get a tach signal from the EDIS module. I am pretty certain that it is wired correctly and the module is brand new so there is nothing wrong there, yet when the starter is turning the engine over, the MJLJ reads the engine sp...

Ive got spark! (yay). turned out the wires for the VR sensor were crossed. Thanks for the suggestion.

Still trying to figure out why i am not getting any spark. It appears that the wiring throughout the systm is all good. Just got a new coil pack and wires so thats not the problem. Is it possible for the EDIS module to somehow "go bad"? I am running non-shielded wires on the VR sensor, wil...

Ok, so i fixed the problem i had with connecting to the MJLJ. I can now input my map (yay). turned out i didnt have the serial support software in the right locations. Anyhow, I have a new problem to attend to. Tried to start the car the other day with the megasquirt and megajolt both programmed, bu...

the comm.jar file is in the same folder as the configuring software and i am fairly certain that java works on my comp. Should i just delete and redownload the whole thing in hopes that i can get everything in the right places? or is there anything else that i could try before doing this?

Im having a bit of a problem communicating with my MJLJ right now. I tested it through hyperterminal and worked so i know it is getting power and desires a connection. The problem i have is that when i pull up the configuring software, it tells me that com port 1 is an unknown serial port, even thou...

ok, that clears that up. I am in the process right now of procuring and installing a new engine. Once it is installed and i will continue my endeavors to run MJLJ. I have almost figured out how to ge tit to connect to my computer. The only problem I see now is that it does not recognize the serial p...

I just noticed something recently. On the screen shots for the configuration there is a button on the bottom right corner that says write flash and the get and update configuration buttons are on the far left side. When i start up my program, after i get past the error message that always comes up, ...

I am going to buy a new serial cable today to see if this helps solve the connection problem. If anyone else thinks of anything else i can attempt it would be GREATLY appreciated. I am thinking that there issomething wrong with java or the MJLJ program that i downloaded because it tells me that ther...

Ok, update. I tried testing the connection through hyperterminal. In the lower left corner it said "connected" and then the amount of time that it has been connected. I typed in the capital "C", but did not get a response from the MJLJ. Why's this? When i went to see if it would ...

I am pretty sure that the power for the MJLJ is spliced into the ECU power but i will double check. I will test the serial connections to see if that is the problem, yet i still do not understand why the tuning program gives me an error message saying that it cannot read configuration. Is this also ...

I purchased the complete MJLJ unit, so that cannot be the problem. I have been using a laptop to try to configure the MJLJ yet when attempting to run the program on my desktop, the same thing as posted earlier appears. I am using a USB to serial bridge to configure the MJLJ, could this cause a probl...

Hey guys, got several problems to address. First off, when i start up the tuning program, it says An Error Occured: There was a problem reading the configuration. Really confused on this one, any help would be appreciated. Next up, I cant get my computer to communicate with the MJLJ. It says Could n...