Search found 5 matches
- Thu Dec 21, 2017 1:58 am
- Forum: CAN mapping discussion
- Topic: Not able to pull any CAN info
- Replies: 7
- Views: 5722
Good news! Got it up and running. I ended up splicing into the CAN wires going into the dash as I wasn't able to get any info from the steering angle sensor plug. I did some research online and found that for a BMW the potential difference (voltage) between the two CAN wires should be .25V with the ...
- Tue Dec 19, 2017 10:38 pm
- Forum: CAN mapping discussion
- Topic: Not able to pull any CAN info
- Replies: 7
- Views: 5722
I'll give that a shot! Before, we tried pulling from the two twisted wires under the dash as shown in the installation instructions. When that didn't work we tried pulling from the connector under the driver's seat as we saw that those two same wires were heading into there as well. I was also looki...
- Mon Dec 18, 2017 11:48 pm
- Forum: CAN mapping discussion
- Topic: Not able to pull any CAN info
- Replies: 7
- Views: 5722
- Mon Dec 18, 2017 6:15 am
- Forum: CAN mapping discussion
- Topic: Not able to pull any CAN info
- Replies: 7
- Views: 5722
- Fri Dec 15, 2017 6:06 pm
- Forum: CAN mapping discussion
- Topic: Not able to pull any CAN info
- Replies: 7
- Views: 5722
Not able to pull any CAN info
Hi all, first of many posts here. I'm having a bit of an issue setting up the Racecapture pro3. I have an E46 M3, so I downloaded the E46 config as a start to get the ball rolling. I can't get anything to pop up either on my tablet or my laptop. I ran debug on the scrip and it comes back [Can device...