Autosport Labs

I have a podium connect box on current firmware that is connected to an AIM MXP 1.2. The device was pulled out of another car with a similar setup (AIM MXG) and worked fine. Now, I am unable to get the Podium to receive any CAN data. The CAN light does not illuminate. I swapped in a Race Capture Pro...

Thanks! This guide is well done. The issue ended up being the baud rate. I forgot to check that when I set it up, and the CAN mapping for the AIM devices doesn't change it automatically. Works well now.

I'm installing a used MXL Pista into my car. Last night, I got everything hooked up and running, but I didn't get any data to the race capture using the stock AIM mapping. Any advice on trouble shooting? This is an older unit (roughly 2011) so I'm wondering if there is some sort of cutoff point wher...

Here is the mapping. Thanks

Thanks Brent! I based the mapping off this document: http://aemelectronics.com/files/pdf/AEMNet%20170116_Public.pdf Podium is physically connected to the system through an AIM 4 port data hub, which is connected to the AIM MXG in the car. I assumed that allows Podium to get CAN messages from both th...

Sorry! You have it correct. I am trying to map fuel pressure to podium connect. As I understand it, fuel pressure comes from my AEM Infinity, but is also displayed correctly on my AIM dash. I have tried to map it to read from both sources on Podium Connect, but get nonsense values from each. Origina...

My car doesn't have a fuel level sender, so I would like to use fuel pressure instead. I'm using podium connect with the standard AIM Mapping. However, fuel pressure is sent to the AIM Dash from the ECU, which is an AEM Infinity. I have tried a variety of settings, but have not been able to map the ...

Thanks for this. Fixed it right up!

Hoping I'm putting this in the right spot. I've got a Podium Connect - Aim integration question. I'm using an AIM rotary steering angle sensor. The reading from this sensor are displayed correctly in Race Connect and Podium Live when the angle measure is "positive" or the wheel is turned t...

Hello, I am in the process of adding a RC pro mark 3 to a car that already has an AIM MXL and a Smartycam. Is it possible to have the RC use the AIM gps, or does it need to use its own? I've got room for both GPS on the roof, but I wondered this for simplicity's sake. I apologize if this has already...