Autosport Labs

Hello brentp-san,

Thank you for your support.

We will check it.
Then i will tell you result.

Hello brentp-san,

i changed baud rate to 1MB.
But still orange ....

Therefore i prepare two of podium what same setting .
But we did not have positive result.
i guess hardware had issue.

Can i ship back to your office?
And check and replace then ship back to us?

i attached picture.

Hello brentp-san,

Thank you for your strongly support.

i will change baud late to 1MB.(maybe current 500)

Hello , gentlly reminder. Even though i introduced podium to shop. But this one did not correctly work. We use podium with AIM solo DL. If use this one , GPS had 3min delay. Then CAN signal value was not correct. Therefore i tried to change to my podium what it had good result . CAN red warning lamp...

Hello , i set up Podium what my friend get. Then i try to use it. Unfortunatery it could not correctly work. i saw everytime CAN red lamp turn on. So, i try to install latest farmware . i install all. But could not resolve. Is it behavior from hardwear issue? Please resolve this . We could not use it.

In this case , could not see signal.

But i think mapping will simuler before case.

Hello Ferg-san,

Thank you for quickly reply.

Actually , i try to other vehicle.
i attached 2 mapping. One was done, other is not....

i think this case can ignor little endian and big endian.

In this case i could see signal.

Hello,

i try to input some value.
i had negative result.
Probably i understood RC mapping rule for bit mode.

One thing , regarding your advice about below.

>Case A: Offset 2, Length 1

i think Offset is 6.
Which is correct?

Hello ,

Of course i tried to along this document.
But i did not get positive result.

Could you tell me more detail.

If check the Bit Mode , how to input Offset and Length in A and B case.

( For example , A case Offset= ? Length=1 .

B case Offset=? Length=12 . )

Hello Brentp-san,

i could directly see CAN mapping data for 1 or 2 length(1(8bit) or 2(16bit) byte).

i want to see except 1 or 2 length.
For example 1 bit type and 12 bit type.

You can see attached file.

Could you tell me how to set them?

Hello brentp ,

Thank you for your advice.

In this case , Do i need add some source to Lua?

If yes , could you tell me how to add source ?

Hello,

i usually use podium for AIM solo/solo2.
i try to use VBOX.
Thou, i got connector & pin.
Could you tell me how to use Podium for VBOX?

i am using Podium with AIM SOLO & SOLO2.
Unfortunatery , i can see only limited CAN signal along SmartyCom Stream.
i want to see other signal that CAN mapping.
If possible , could you tell me how to setting (hard & soft)?

Next year some country will bigin 5G network.
Thou , we can use this network.
Please update some system for this changing.
Especially , i want to request what extend podium system.

Hi,

i had simular situation.

U can see above title.