Autosport Labs

has any one had any success with the rev limiter on the files page i have built one and the coil wires are earthing out all the time even without the mj input wire connected ive obviously make a mistake somewhere i would like to try again and build a new one from scratch has anyone built one that wo...

login to capripower and p.m me then i can send you my number and give you all the info you want

good to hear your up and running ivan

just out of interest if you are using the map sensor where have you took a feed off the inlet manifold?

i run mine off number 2 and 3 on the inlet manifold with some fine bore pipe to reduce pulsing i get a steady reading of around 50 kpa at idle

the missing tooth should not be at no.1 tdc please dont make this mistake like so many others have the missing tooth should be 90 degrees past the sensor (for a 4 cylinder engine)at tdc sorry to correct you but ive seen you mention this on another post it will be very confusing for someone if they s...

dont know if youve looked at this option already why not make a toothed wheel to fit on the flywheel similar to the ford enduro engine this has raised blocks machined into the flywheel (oposite side to the clutch) then the sensor points at the flywheel at 90 degrees vertical to a horizontal wheel ju...

ivan you dont have to put anything in manually the map file that you download can be opened with the tuning software and all the values are loaded in put the mj tuning program on your pc then load the map file then you can copy it over to your laptop or easier still save the map file on a disc and o...

run the MJLJ tuning software then go to (file) then (open) in the pull down menu find the xe map and load it then (with mj connected) you can update the config click on get config to make sure it was sent ok

ivan ive posted a map in the files section it is only a basic map but it is the one im using at the moment until i can fine tune it
i started off with pioneerx's 1.8 8v map and retarded it in places because of pinging

hi chris at the mo im using some leads i made up from some hotwires from halfords with some ford zetec ends fitted on the coil pack end took off an old set going to get a custom set made soon thanks for the info on the base map chris i will check it out just to add to how things are going i installe...

cheers brent i will try what you suggest and let you know how it works out
ivan i will let you know when i have a working map good to find someone else with the same engine etc which model opel do you have ?

its running and on the road ive just got to map it propley its running on the map that the unit came with for now and seems fine (is this the map that you use brent or is it just a test map?) cheers brent for the megajolt and if anyone has or knows where i can find a map for the xe that would be a g...