Autosport Labs

Next installment! I'm showing approx 1.5 v between pin 6 and ground dropping down to approx 0.5 v by sucking on the pipe. no increase when blow! also getting the same drop between ground pin 5 and R4 but no reading at all between ground andthe far side of C8! and nothing at R1. does this make sense ...

Hi Brent
yes when the engine is running the software reads the RPM and you can see the cell move ( advance changes) along a single line depending on the RPM, i can also read and write different MAPs to the unit as well as see them change configure when i flip the "MAP" swtich.
regards
Matt

Thanks NITROPIXIE i'll try that tomorrow in the light. Thanks for getting back to me too Brent, the software shows 0kPA when connected and the unit fully powered up. Everything seems to working fine including switching maps on the fly. thanks for both your help in this I'll post readings tomorrow re...

HI checked the pins on the map sensor as per the instructions and can confirm that there is 5v between pins 4 and 5. so whats next? currently reading no pressure at all when powered up.
regards
Matt

Hi we have been running v4 for a while now with no issues, however came yesterday to add a second map, when on testing realised that there was no pressure reading. i'm assuming that that it has been running in "2D" mode. however any ideas why it would stop working ( i sure it was working o...

Hi Everyone
does anyone out there have a a map for a stock 875cc Hillman Imp. We've just purchased the the (Megajolt Lite Jr V4 (MAP Kit) from Brent!!

many thanks
Matt & Josh

Has anyone got a definitive wiring guide or can tell me where to find one for the MJLJ ver 3 with TPS to edis etc.

Thanks
Matt

Hi All
Thanks for all your help already.
Has anyone complied a uk parts list from www.rsww.co.uk yet for MegaJolt Lite Jr. Version 3 using a TPS. If so please can they let me have it and whether once built everything worked ok.
Thanks
Matt