Hard Starting....

mayngo · Post by **mayngo** » Wed Jun 09, 2010 2:46 am

New Megajolt installation, went very well and very happy with performance but I'm having a little difficulty when I go to start it. I always have to crank it for about 4 or 5 seconds, let go of the key and then it always starts on the second try, after about the same amount of cranking. I don't believe engine is flooding with gas because it does it on initial cold start up and after it's been sitting for a half an hour after long drive. I have not tried shutting it off and immediately starting it back up yet, I will try that tomorrow.

Any ideas?

Post by **brentp** » Thu Jun 17, 2010 6:08 am

Sorry for the late reply. Have you tried adjusting the cranking advance (in the software)? Does it pop or try to catch, at all?

mayngo · Post by **mayngo** » Thu Jun 17, 2010 11:40 am

It may be a flooding issue, but where should the cranking advance be?

Thanks