Runs w/o advance and will not communicate with laptop

General Topics for configuring, operating and tuning the Megajolt. Also see the <a href="http://www.autosportlabs.net/MJLJ_V4_Operation_Guide">Operation Guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
manx3094
Posts: 15
Joined: Fri Apr 06, 2012 10:45 pm

Runs w/o advance and will not communicate with laptop

Post by manx3094 »

My VW motor runs but the ignition will not advance. This system has been in use for about 3 years or so. When I got the car out this year it just didn't seem to run very good.
I cannot get the laptop to talk to the MegaJolt.
I checked the advance and there is none.
I have gone through the "verifying signals" section and everything seems to check out except EDIS PIN 1 to ground should be 12 volts with the key on and the engine off. I have just millivolts.
I have about 5.5 volts with the engine running at this position.
The green light is illuminated on the MegaJolt.
Any suggestions?

brentp
Site Admin
Posts: 6282
Joined: Wed Jan 24, 2007 6:36 am

Post by brentp »

Hi,

Did you make any progress on this or are you still stuck?
Brent Picasso
CEO and Founder, Autosport Labs
Facebook | Twitter

Post Reply