Page 1 of 1
Required Clearance Between Trigger Wheel Teeth and Sensor ?
Posted: Sun Aug 01, 2004 6:40 am
by Pantera
How much clearance is required between teeth on the trigger wheel and the sensor ? Is there a minimum and maximum dimension ? I assume that all EDIS systems are the same, but in case it is pertinent, I have an EDIS-8 system.
Thanks !
its
Posted: Sun Aug 01, 2004 8:45 am
by Josh_b
about 1mm,
Clearance
Posted: Tue Sep 14, 2004 9:50 pm
by Oliver Sedlacek
I set up a test rig and looked at the VR signal on an oscilloscope. You can see the trace at <a href="
http://community.webshots.com/album/187 ... ebshots</a> . The strength of the signal increases as you bring the sensor closer to the wheel. 1-2mm looks sensible.