Page 1 of 1
Ford ESC
Posted: Sat Apr 12, 2008 1:11 pm
by varnish5000
Hi I've just been given a ford esc ignition control box.
It has a vacuum take off going straight into the control unit.
Is this unit suitable for use with MJLJ?
I'm guessing not.
Thanks
Varnish
Posted: Sat Apr 12, 2008 2:34 pm
by MartinM
Hi - 'fraid not. You need a standard EDIS-4, EDIS-6 or EDIS-8.
Posted: Sun Apr 13, 2008 1:28 am
by DannyP
You might be able to open it up and salvage the MAP sensor though.
Posted: Sun Apr 13, 2008 7:56 am
by KLAS
DannyP wrote:You might be able to open it up and salvage the MAP sensor though.
don't think so, Ford map sensors normally produce a frequency not a voltage
Posted: Mon Apr 14, 2008 1:43 am
by DannyP
Sorry, now I know
Posted: Fri Apr 18, 2008 8:22 pm
by capri_turbo
KLAS wrote:DannyP wrote:You might be able to open it up and salvage the MAP sensor though.
don't think so, Ford map sensors normally produce a frequency not a voltage
standard ford map sensors use a similar freescale unit to that of the MJLJ, BUT it is the non ported type and is sealed in the ford unit. There is also a PIC in there which must do the conversion to a frequency.