Page 1 of 1
EDIS, Coil Pack Pins
Posted: Fri Feb 13, 2009 11:38 am
by luke6040
Hi ,
Im sure i saw a post about putting new wires into the edis pins but i cant seem to find it.
Any ideas.
Thanks.
Posted: Fri Feb 13, 2009 6:41 pm
by Ken555
Posted: Sat Feb 14, 2009 8:36 pm
by luke6040
Yea thats it. Thanks, Nice page btw, vry usfull.
Posted: Fri Feb 20, 2009 5:33 pm
by luke6040
I have just made a start folowing ur steps and am stuck on the step. "Then there are two small tang on the pin, top and bottom, that when pushed down out of the way releases it, pulling the wire from the back now should allow it out" what are tangs?
Posted: Fri Feb 20, 2009 5:39 pm
by Ken555
luke6040 wrote:what are tangs?
Small sticky out bits
, sometimes called barbs
Think of a arrow shape, to pull it out you need to press in the \ and /.
Posted: Fri Feb 20, 2009 5:45 pm
by luke6040
thanks for super fast reply.
Thats what i was looking for but im lost lol, is there a magic way to get to them that im missin.
Posted: Fri Feb 20, 2009 5:53 pm
by Ken555
luke6040 wrote:thanks for super fast reply.
Thats what i was looking for but im lost lol, is there a magic way to get to them that im missin.
I used a small needle to push them in.
Posted: Fri Feb 20, 2009 6:04 pm
by luke6040
i think ill just buy some new 1s cuz mine are cleary lame!