Autosport Labs

I want to know if MJ can operate without map or tps input. if so what are the settings I need to do to run this way. My thoughts are that it will just read RPM and
make timing adjustments from this reading ??

Yes, my first maps were this way. Make all ten bins the same on the vertical axis in the map.

Then I added the load sensing later. My old dizzy was centrifugal only.

You could if you wanted put a potential resistor on the dash in place of a tps and have an on the fly map change, should you wish, with a choice of ten maps.

I have map sensing at the time but want to do some tuning without the MJ sensing the load from map.
does the number in the bins ( vertical ) have an effect on how the MJ reacts ? what I mean is if I set them all to
say 10 or to 50 would this change anything , or should I just make sure they are all the same ? Thanks for your help.

I did my map based on the full-throttle setting, which is the bottom horizontal row. Then just make the other nine rows match the first one.