MJLJ Connector pin-out?

EDIS and Megajolt installation related topics. Be sure to review the <a href="http://www.autosportlabs.net/MJLJ_V4_vehicle_installation_guide">Vehicle installation guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
Zottlander
Posts: 4
Joined: Thu Mar 25, 2010 7:21 pm
Location: NY

MJLJ Connector pin-out?

Post by Zottlander »

Ok, I know this is a dumb question, but i would like to not blow up the MJLJ.

When the wiring diagram says connector pin-out, is this looking at the MJLJ itself
and the power is on the right? Or is this looking at the end of the cable?

The reason i ask this is because the cable connector has sockets that plug onto the pins of the
MJLJ itself.

Thanks for the help....

BRUCEROE
Posts: 96
Joined: Wed Mar 03, 2010 10:00 pm

MJLJ PIN OUT

Post by BRUCEROE »

The picture MEGAJOLT LITE JR V4.X CONNECTOR PINOUT is looking at the connector from outside the case. Notice the screw heads at the corners. The pin at lower right is +12v; you could verify this by tracing it back to the + (9V battery) test point on the circuit board. Incidently that is connector pin 1. The upper right pin is GND (pin 9); same check. Lower left (pin 8) is AUX INPUT,upper left (pin 16) is COIL POWER. Bruce Roe

Post Reply