Wire size
Posted: Sun Jun 08, 2014 5:10 pm
Hello peeps,
I have a question about wire size. I am planning on pre-wiring the RCP with a multi pin connector but not sure what wire size/s to use. I have searched through the RCP manual and can't find anything regarding wire sizes. If I missed this section in the manual maybe someone can direct me to the correct section. Will the wire size be dependent on the type of sensor being used or can I use the same size wire for all channels. What size wire should I use for the power supply?
Any help would be appreciated.
I have a question about wire size. I am planning on pre-wiring the RCP with a multi pin connector but not sure what wire size/s to use. I have searched through the RCP manual and can't find anything regarding wire sizes. If I missed this section in the manual maybe someone can direct me to the correct section. Will the wire size be dependent on the type of sensor being used or can I use the same size wire for all channels. What size wire should I use for the power supply?
Any help would be appreciated.