Not completing telemetry handshake
Posted: Sun Jun 29, 2014 2:38 am
I just fired up the telemetry unit for the first time in my garage. The network LED is blinking slowly, so I think it found the network (ATT). The transmit and receive LEDs are also blinking, but not continuously... I'm guessing it is trying to complete some handshake with the server.
I created an event (did not see an ad hoc event created for my device). I added my device to the event, and made sure I used the device ID from the site in my configuration of the device through Race Analyzer.
But when I click on my device in the event, I just get a blank page. If it was working properly, I should see a dashboard, right?
What am I missing?
I created an event (did not see an ad hoc event created for my device). I added my device to the event, and made sure I used the device ID from the site in my configuration of the device through Race Analyzer.
But when I click on my device in the event, I just get a blank page. If it was working properly, I should see a dashboard, right?
What am I missing?
