Megasquirt integration question...
Posted: Tue Apr 02, 2019 3:29 pm
Howdy,
I'm confused about the following statement in https://wiki.autosportlabs.com/Megasquirt_CAN
RaceCapture/Pro MK
Use the CAN High and Low connections from either CAN1 or CAN2 on the 24 pin Molex harness. Typically CAN1 is used, so you would use CAN 1 High and CAN 2 HIgh.
Shouldn't this say... you would use CAN High and CAN 1 Low????
Is this a typo or am I confused?[/u]
I'm confused about the following statement in https://wiki.autosportlabs.com/Megasquirt_CAN
RaceCapture/Pro MK
Use the CAN High and Low connections from either CAN1 or CAN2 on the 24 pin Molex harness. Typically CAN1 is used, so you would use CAN 1 High and CAN 2 HIgh.
Shouldn't this say... you would use CAN High and CAN 1 Low????
Is this a typo or am I confused?[/u]