Page 1 of 1

Bulkhead fitting in UK

Posted: Thu Oct 19, 2006 10:51 am
by klj895w
I can't the vacuum hose bulkhead fitting in the UK anywhere. Can someone help me please? Thanks, David

Yeah, they seem pretty

Posted: Thu Oct 19, 2006 11:48 am
by MartinM
Yeah, they seem pretty hard/impossible to find. I'm sure they must exist somewhere, but I've never managed to find them...

There are (at least) two DIY options:

- run the pipe from the manifold in through a grommet'ed hole in the end plate and direct to the MAP sensor. Make it a tight fit, so that moving the pipe outside the case doesn't put any strain on the MAP sensor, but not a constricting fit

- get something like a 4-6mm bolt, cut the head off and drill a 2-4mm hole through it lengthways. Use two nuts to secure, one either side

over here there are small

Posted: Mon Oct 23, 2006 7:44 am
by KLAS
over here there are small bulkhead fittings normaly used by RC car buildern

http://www1.conrad.de/xl/2000_2999/2300 ... FB.EPS.jpg

not to expensive and they are metal

You could try

Posted: Fri Nov 03, 2006 12:47 pm
by Pmoffatt
THe clunk tank kit from www.nitroflight.com.

Go to the fueling section, it's in there - £3.20 inc VAT though. That has a bulkhead connector if you look at it, designed for passing fuel hose through plastic tanks, includes grommets and washers too.

You could possibly use that 99p inline fuel filter too, as it's a two piece screw together type, just take the filtering gauze out.