Autosport Labs

try using the same wire as the standard install to the tach out and if it is bouncy then use the PIP signal. i used the PIP signal on my smiths gauge as the tach out from the MJ was bouncy and not reliable.

so i can just tap into the PIP signal? think i need to read the wiki again

I have connected up my rev counter to the output from megajolt. It works but it is very bounucy and also when coming off the throttle it tends to zero then go back to normal or if i am on part throttlewit goes to zero. Should i be using a different method to run the tach? It is an old smiths tach i ...

well i have now found out that the 29 and 14 iwas an attempt by the creator to try and cure an idle problem. So i have put on the aldon yellow dizzy map that you did KLAS and it is much better.

well i thinki might try and tweak this one. or i have downloaded a copy of an Aldon Yellow dizzy so i might even try that.

Well i have had the MJ on for a while now and it runs ok but i always seem to have problnms pulling away from the lights and i have to feather the clutch a fair bit and give it a fair bit of gas so it doesnt stall. I have one of teh maps from this site but am sure it could be better. I am not sure t...