Autosport Labs

My Megajolt system was mapped on a rolling road at the end of the summer last year. Recently I had cause to look at the map, and I can see that the load parameters are calibrated from 0 - 255. My system works from a throttle position sensor which is calibrated from 0 -100. The result is that the Meg...

Does anyone have a map for a 2 litre pinto, twin 45 webbers, FR32 cam.
I am running lastest firmware and have a calibrated Throttle position sensor fitted

Many thanks

Phil

After fiddling a few wires I am now getting a reading from the TPS and have managed to calibrate it. Readings attached

Phil

Thanks Martin.

I will do some tests and report back. It may not be for a day or two due to work comitments

These are the voltages taken from the plug (not plugged into the TPS).
Can I test the TPS standalone without the powwer to it?

I have just installed a Megajolt on my 2lt Pinto, but am having problems getting a reading from the TPS when trying to calibrate it using software. I have the following TPS Ford PBT GF30 OTS 928F 98989 GA 4F29B It is wired as follows +5V to pin 1 Signal to pin 2 Ground to pin 3 I am getting the foll...

Panic over. It appears to have now worked

many thanks for all of your help

Regards

phil

I have just realised that i did not download the Firmware programming software. I have now done this and it accepts the command hc08sprg.exe ......

It is now just counting on calibration break pulse. count ...

it has got to over 1000 so I have disconnected the power

Any ideas what to do now?

The following files are listed 09/05/2008 16:15 <DIR> . 09/05/2008 16:15 <DIR> .. 09/05/2008 16:14 723 data 9-5-8.mjlj 09/04/2008 19:58 1,987,652 mjljConfig_v3.2.1.exe 09/05/2008 16:15 7,850 mjlJunior_V3.2.1.s19 3 File(s) 1,996,225 bytes 2 Dir(s) 28,315,385,856 bytes free When I saved the controller...

Thanks Brent

I have put the command in correctly and still get a message saying 'hc08sprg.exe' is not recognised as an internal or external command, operable program or batch file.

Any more ideas?

Thank for that. I can now get to the directory. I now have another error message come up when i type in hc08sprg.exe COM1 etc. It sais 'hco08.exe' is not recognised as an internal or external command, operable program or batch file.

Any ideas?

I bought my system secondhand and have noticed that the coil has been wired up back to front. Pin 10 EDIS to pin 1 coil and pin 12 EDIS to pin 3 coil, whereas the installation instructions state Pin 10 EDIS to pin 3 coil and pin 12 EDIS to pin 1 coil. Will this cause any problems? When I did a quick...

I am trying to upgrade my megajolt fron V3 to V3.2.1. I have saved the file to my pc and am following the instructions as follows Open a command window (Click Start / Run, and enter 'cmd') and then navigate to the directory where you downloaded your MJLJ files. My cursor sais c:\documents and settin...