Autosport Labs

Was thinking of writing a small code that could let you modify, datalog with a palm. Just haven't took the time. I know with Megasquirt, the code is really weasy for the palm. So don't think can be really way harder with MegajoltLite, just need to figure what sends what.

yeah, I was using 1.5.0 JRE, I will get 1.4.2 tomorrow, just a bit weird that 1.0.0 loads but not the newer versions. I will see from there, don't really want to run in wine... that would be my very last option.

ok, fixed the previous problem, it just wasn't using the Sun Java version... now not sure it the problem is related to. Gtk is correct since I using MegatUnix correctly and it needed gtk to build. ok, I seem to be able to run version 1.0.0. But crashed when try to get info, well didn't have the unit...

I get a couple errors try to run the tuning software... I will try to look at RxTx and see from there, are you able to get into the software at all?

I get error on couple of lines...

Was wondering if anyone got the tuning software running with linux, so far I got Java installed and works fine, just not sure how to run the .jar under linux, I'm used to run it with XP but my new laptop is equipped with fedora core 3. And I don't want to install anything microsoft on that one lapto...

First about two weeks ago, the engine started perfectly, thtat's was when I had all the wires around laying just for a test. Started right up. I then decided to run the wire clean thru engine bay, solidify sensor and even got the toothed wheel machined so it's now perfectly center. never been able t...

anyone can tell me... how do you proceed with updating a processor that had a earlier version to the latest 2.0.3.

ok, from the description you want traction control, on all other Megasquirt & Megaother units, it's only a switch that you activate manually when leaving from the line. Traction control could be added if a car already has ABS so then you can use the signal from the different wheels.. But in orde...

I think it's been like one year since I've been trying to start this engine using MSnS, I had purchased a MJLite Jr a while ago and decided to give it a try. Started right up, even better than when I was running a vw 1.8L 8v with distributor, with Megasquirt & Megaspark. Now have a modified vw 2...

just wondering how can I update my code to newer v2.0.3 is there a way else then using seperate programmer? Thanks Math

Hi,
would like to know if I want to make mods to the chip code, can I use same program as Megasquirt to compile to .s19.

And what software I could use to modify the PC software if using Win XP.

Will let everyone know my mods.

MAth

Are you also using it as a full throttle gear shift system? If so what rpm did you set it up? Was looking to use one experimental on my car and don't know what starting rpm I could try. Thanks.

Math

useless after seing other thread.

I think you would need better to check on Megasquirt yahoo forum, this forum is about a diy ignition system using some off Ford EDIS parts combined with the diy controller.

that's where I will order my boxes from, it's about 15$ if I remember correctly.

Math