Autosport Labs

Demo Video: https://www.youtube.com/watch?v=b4YTmlmBw5Q This isn't very complicated, get RaceCapture working in Raspberry Pi First. Go grab yourself the buttons that you will need 2 or 3 buttons: Left, Right and "ESC" though Left and Right are really all you need. ESC just bring your back ...

brentp wrote:Hi,

You can connect one tablet via the Bluetooth interface (if the BT module is installed) and you can connect a 2nd tablet via the WiFi interface as well, for a total of two.

Hope this helps!

Is it possible to have the mk2 connect via USB to raspberry pi and to Android via Bluetooth?

Anyone?

I'm assuming this won't work with race capture/track due to lack of LUA?

Paul

Hi Brent, a got it to work, I didn't do anything however. After about 4 or 5 minutes it connected and was solid. Not sure why it takes so long for the Pi to read the Race Capture.

You can connect AnalogX to RaceCapture/Track, but it will only work with sources that have linear mappings. Example: 0.5v = 0 PSI, 4.5v = 150 PSI, as found on an oil pressure sensor, and other sensors with a straight-line linear mapping, such as wideband AFR sensors. Sensor with a curved mapping (l...

I got my PI3 running with the standard 7" screen this morning in about 45 minutes the benefit of 20+ years of Linux experience. However RC app doesn't seem to be getting any data - the setup shows it's connected to USB but when I swipe to the "Raw Channels" screen I get "Waiting ...

My goal is to replace my current dash 100% with an Android tablet connected to RaceCapture.

I've got a Miata gauge cluster blank panel as a starting point.

Related topic, is "check engine" something that RaceCapture is aware of on CAN or OBD2?

I was thinking of using this to convert my Miata fuel sender into 5v.

http://www.ironcanyonmotorsports.com/icm-fuel-sender/

Am I correct that I can use AnalogX to add analog sensors to my CAN bus that my /Track can then display? I've got a '90 Miata with a 2013 Ecotec engine, the engine is CAN but the car isn't, what I'm hoping to do is add fuel sensor, oil pressure, wideband and maybe one other sensors onto the CAN bus ...

Given my Racecapture/Track is installed with the cable facing the front of the car does that mean I need to tweak some of the settings in Accel/Gyro setup such as inverting pitch? What about X, Y, Z acceleration?

Paul

No it seems to have identified sessions but not actually logged the times.

Had my car and race capture on track yesterday for the the first time. The track was detected, and lap timing started up automatically. However, when I got back to the pits to run analysis of my session there were no laps recorded just empty sessions. This was unfortunate because I had the opportuni...

brentp wrote:Nice. Proclip mounts are awesome!

Now I need to figure out my Canbus mappings for GMLan Ecotec 2.4.

Got it installed, similar to someone else I believe that posted a Miata.

Have a Nexus 7 installed on the dash using a Proclip Mount.