Autosport Labs

Can someone verify the GM temp. sensor (Closed element) settings are correct and working? I hooked up a sensor and the values I am getting are not making sense. I used a 2.2k resistor and the preset curve, but I am seeing 168 degrees with an ambient temps in the 90's with the engine cold. I am tryin...

Has anyone had any luck using this display with their pi? Something like these: https://www.amazon.com/VSDISPLAY-1280X480-Screen-LQ123K1LG03-Controller/dp/B07QGDB1MX/ref=sr_1_8?dchild=1&keywords=12.3%22+display&qid=1622228556&sr=8-8 https://www.amazon.com/12-3-inch-1920X720-HSD123IPW1-A0...

I am getting data from the Megasquirt on CAN Channel 1533 for the oil pressure sensor, but the data does not make sense from a numbers perspective. The Can data is coming across in the 7000 range when the sensor is showing 30 psi in Tunerstudio. Instead of continuing to bang my head against the wall...

I am having an issue getting the correct CAN ID's for Generic Sensor input 1 and 2. I brought the oil pressure into Analog input 2 and set it up as generic sensor 2 with plans to use Analog input 1 as oil temp. I looked up the setting in the Megasquirt manuals and it looks like the real time broadca...

Just to round out the thread, I found these settings work for AFR with an MS3 Pro PNP:
CAN ID: 1523
Offset: 4
Length: 2
/10*1+0

No one else has this issue? Could there be a setting in the MS that is not correct?

The preset in the RaceCapture unit is 1521 offset 4, but when looking at the data, the value matches the AFR1 Target table, not the actual AFR.

I was able to get the CAN data working between the MS and RaceCapture, but I noticed that the numbers coming in for the AFR are actually the AFR Target, not the AFR data from the Megasquirt. I noticed the numbers on the RaceCapture for AFR did not match the one shown on the gauge and then verified t...

I have been helping a buddy get his Racecapture set-up in his Miata. We are removing the gauge cluster and going to a Pi dash set-up. We plan on mounting the RaceCapture unit in the area where the stereo would normally be and make a block off plate. The problem we ran into is that we wanted to have ...

Since a lot of people seem to be running a Megasquirt (Man not be enough demand for this), is there a way to get RaceCapture as the source for TunerStudio instead of the Megasquirt? Reason I ask, if you were using a Pi Dash to run RaceCapture and as a dash interface for your data logging and Megasqu...