Autosport Labs

Just wanted to close the loop here and say I got it figured out. You have to have 2420 in the canbus tab, big endian selected, and whatever offset and bit length works.

If anyone has any questions, message me and I might be able to help.

Posting the remaining screenshots

I've reviewed this thread, as well as the OBD2 wiki (https://wiki.autosportlabs.com/RC_OBDII), and I still can't get the OBD2 PIDs I need to read correctly on my racecapture. I need to log short term and long term fuel trims for my tuner (for each bank), and it looks like those are standard OBD2 PID...

Found the problem, just needed an AND

function accusump()
local rpm = getTimerRpm(0)
if 400 < rpm AND rpm < 1750 then
setGpio(0, 1)
println ("Accusump Disabled")
else
setGpio(0, 0)
println ("Accusump Enabled")
end
end

I'm hoping someone can take quick look at the simple scripts I'm trying to run on my racecapture pro v3. Basically I have the three GPIOs set to output mode and connected to a relay board. The intent of my scripts are just to cycle normally open and normally closed relays based on measured values. S...

Replying to an old post here, but did cutting wire 8 and re-terminating work? I have the same problem (E36 M3)