Map needed PLEASE PLEASE PLEASE

darrenxr · Post by **darrenxr** » Mon Dec 22, 2008 10:38 pm

I have just finshed my mk2 fiesta running a fiesta rs 1800 zetec with r1 motorbike carbs.

I am running mjlj.

I am just looking for a safe start up map that will allow me to drive the car to get mapped properly if needed.

If i can get a map that will be very well suited though that would be excellent

Thank you very very much.

Darren

Post by **brentp** » Mon Dec 22, 2008 11:43 pm

Hi Darren,

the factory map will work well enough for you to drive down to the rolling road. It sounds like you might be running TPS- you may want to consider calibrating your TPS, following this process: http://www.autosportlabs.net/MJLJ_V4_Op ... alibration

It's something you will need to do regardless, so you might as well do it in advance.

Regards,

darrenxr · Post by **darrenxr** » Mon Dec 22, 2008 11:56 pm

Sadly i am not running tps... will be using map for load.

Although the bike carbs do have a tps but not sure if that would work.

Quite a few people have said the base map will allow me to drive it so that all good for now.

Thank you.

Post by **brentp** » Tue Dec 23, 2008 12:07 am

Good.. As long as you have a stable vacuum reading the MAP sensor option works very well.

Best of luck during tuning! Please share your map when done in the Ignition MAP library..

Regards,

darrenxr · Post by **darrenxr** » Tue Dec 23, 2008 12:09 am

I will indeed

Thank you