Sequential shift lights

gav · Post by **gav** » Fri Nov 27, 2009 3:39 pm

Hi, just wondering if anyone has any pics of these installed on your dash etc, did you just mount them from behind and drill some holes through the dash or use a clear lens etc? Ta

Ken555 · Post by **Ken555** » Fri Nov 27, 2009 9:18 pm

At the bottom of the rev counter.

Video here
http://www.ken555.plus.com/gtm/may08.html

Post by **brentp** » Sat Nov 28, 2009 1:27 am

Ken's installation is one of my favorite's. super clean.

DannyP · Post by **DannyP** » Sat Nov 28, 2009 2:02 am

Mine are the three red lights, L-R on my combi gauge. The lights were unused and are of high enough resistance to be driven directly by Megajolt. Easy as running three wires to the Jolt and an ignition hot to the other side of the bulbs. Blue is high beams.

gav · Post by **gav** » Sat Nov 28, 2009 2:23 pm

Cheers, are they individual led's or did you use the clusters and a plastic cover?

gav · Post by **gav** » Fri Dec 04, 2009 10:51 am

Bump

DannyP · Post by **DannyP** » Fri Dec 04, 2009 1:29 pm

If you're talking to me, they are little 12v bulbs and the gauge already had the red plastic lenses built in. All I had to do was wire it up, lucky me

gav · Post by **gav** » Fri Dec 04, 2009 1:48 pm

I meant Ken but thanks for the reply

Ken555 · Post by **Ken555** » Fri Dec 04, 2009 3:45 pm

gav wrote:I meant Ken but thanks for the reply

Sorry Gav I though you meant DannyP

Yes individual LED's, soldered to a piece of vero board, then hot glued to the rear of the dial face.

To prevent the light shining through the other leds, I placed then in a small tube, I think it was a cut up-biro type pen.

gav · Post by **gav** » Fri Dec 04, 2009 3:50 pm

Cheers, where did you get the little covers to make them look like one light?

Ken555 · Post by **Ken555** » Fri Dec 04, 2009 6:31 pm

There is no cover, just drilled the face of the gauge and mounted behind.

gav · Post by **gav** » Mon Dec 07, 2009 10:02 am

Ah i was expecting to see clusters of 4 led's like in the kit