Missing components from kit.

H8my408 · Post by **H8my408** » Sat Mar 27, 2010 9:11 pm

I recently ordered the MJLJ DIY kit, and soldered it together lastnight. As I was going through, I came across a flaw = I only had one "Schottky Diode." I took all precautions to not allow a slip or bounce of a component. Where can I go to get a replacement, and what are it's specs so I can make sure I'm getting the right one?

I am in Lynnwood, Washington. And if I'm not just an idiot, so is Autosport...
Brent - I left a message on the phone with my contact information.

I hope for an easy solution, as I am foaming at the mouth. My project is at it's final stages of the buildup, into life! The minutes are days!

Jonathan

Edit: It's D7 to verify exact component required.

Post by **brentp** » Sun Mar 28, 2010 2:58 am

Hi Johnathan,

We got your message- sorry for the inconvenience. Good news- D7 isn't critical- so you can proceed with your build and testing- we will get one out to you in person or we'll drop it in the mail for you and you can add it later on.

Thanks,

H8my408 · Post by **H8my408** » Sun Mar 28, 2010 7:30 pm

In my mind, I've replied to this already, however, if we link up over the phone, I can rendezvous somewhere local.

As for my opinion of the kit, I think it's a smash! You shouldnt even have the pre-assembled kits!

"DIY? Oh hell yes. I even assembled the computer!"

H8my408 · Post by **H8my408** » Thu Apr 01, 2010 6:55 am

Recieved the D7 component in the mail today! Thanks again Brent! Cant wait to update everyone with the introduction and completion of the project, all at the same time.

Jonathan.