Spout connector

General Topics for configuring, operating and tuning the Megajolt. Also see the <a href="http://www.autosportlabs.net/MJLJ_V4_Operation_Guide">Operation Guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
Oldgringo
Posts: 11
Joined: Thu Jul 15, 2010 3:06 am

Spout connector

Post by Oldgringo »

Is there any benefit to leaving the ford spout connector in the loop when wiring a new harness?

NITROPIXIE
Posts: 704
Joined: Sun Sep 07, 2008 1:54 pm
Location: Fareham, GB

Post by NITROPIXIE »

Spout or spark output is generally used on Ford TFI ignition systems. EDIS's uses the equivalent SAW or Spark Angle Word. Are you confusing yourself or did you read it somewhere on the internet????[/url]
1310 A-series Mini, lightened and built myself. V4 board and loving it

Rasputin22 - The Mini Forum
Rasputin22 - MK1 Golf Forum

Megajolt repair for the UK available

Oldgringo
Posts: 11
Joined: Thu Jul 15, 2010 3:06 am

no internet involved. (Maybe some confusion though)

Post by Oldgringo »

I just bought a used EDIS6 box from this site and the plug/wiring stub on it has (what I describe as) a spout connector in the wire from the 3 rd pin. Red (SAW) wire, black two prong plug in series, gray plug that seems to just make continuity in the 3 rd red SAW wire...

was just wondering if it had a purpose in this set up. Or do I just eliminate it.

TYVM, OG

AndyGT6
Posts: 25
Joined: Thu Sep 06, 2007 12:13 pm
Location: Cheshire

Post by AndyGT6 »

My USA sourced EDIS6 unit also had the spout connector, I just cut it off and threw it in the bin.

Andy

AndyGT6
Posts: 25
Joined: Thu Sep 06, 2007 12:13 pm
Location: Cheshire

Post by AndyGT6 »

My USA sourced EDIS6 unit also had the spout connector, I just cut it off and threw it in the bin.

Andy

Oldgringo
Posts: 11
Joined: Thu Jul 15, 2010 3:06 am

Ty Andy

Post by Oldgringo »

I could not see any use for disconnecting the saw signal.


Ty again, OG

Oldgringo
Posts: 11
Joined: Thu Jul 15, 2010 3:06 am

Ty Andy

Post by Oldgringo »

I could not see any use for disconnecting the saw signal.


Ty again, OG

Post Reply