Hard Cut Rev Limiter installed but not working.

RonanVauxhallNova · Post by **RonanVauxhallNova** » Tue Jan 28, 2014 9:57 pm

I installed my hard cut rev limiter board into the case. I ran the coil wire from the COIL-POWER pin on the megajolt to the middle pin on the coil.
Does anyone have any idea what I am doing wrong?[/b]

Not Anumber · Post by **Not Anumber** » Mon Feb 10, 2014 2:50 pm

Is it not powering the coil or is it not breaking the connection when the rev limit is reached ?

RonanVauxhallNova · Post by **RonanVauxhallNova** » Sat May 03, 2014 3:14 pm

I have the limiter feeding the coil, it just won't break the power when the limit is reached.

Post by **brentp** » Sat May 03, 2014 4:27 pm

Hi RonanVauxhallNova,

Can you post a picture of the wiring between Megajolt and the hard rev limiter board?

Also, when you connect the Megajolt up to your computer, does it show run-time activity? RPM, advance changing, etc?