MAP to TPS

hillmanwings · Post by **hillmanwings** » Mon Jul 14, 2014 2:54 am

Hi, I have a MAP optioned MJLJ, and I want to change to a TPS option. Can I simply solder in the additional components or do I have to remove the components for the MAP option?
Justin

toenee · Post by **toenee** » Sat Jul 19, 2014 7:13 pm

Yes the instructions are somewhere in here, you can get all the bits needed in the autosport labs shop. Not sure about leaving them in place, but I know you can't use both.

Post by **brentp** » Thu Aug 14, 2014 9:06 pm

You can safely leave the components in place, just be sure to disconnect the TPS from the molex connector.

hillmanwings · Post by **hillmanwings** » Fri Aug 15, 2014 12:21 am

Thanks for the reply. I have sorted this out. Removed the 270 ohm resistor from the MAP circuit and added the 7 components for the TPS circuit. Calibrated the TPS, works great.

Post by **brentp** » Fri Aug 15, 2014 5:05 am

fantastic. thanks for the update