Support for OMEX ECUs / RS232 to CAN

Mac944 · Post by **Mac944** » Wed Aug 12, 2015 11:25 am

Hi,

Recently found out about Race Capture Pro and am very interested in installing in my Porsche race car, however I run an Omex 600 ecu which has a serial/RS232.

It doesn't look as though Omex is currently supported but wondered if using an adapter to convert RS232 to CAN might work?

Thanks

finse · Post by **finse** » Wed Aug 26, 2015 8:48 pm

I am working on something similar for my Subaru. I am successfully pulling data from my ecu with an arduino and sending the data via CAN to the RCP.

It can be done!

Post by **brentp** » Mon Oct 19, 2015 5:49 pm

Hi Mac944,

A recent firmware release added Serial I/O communications to RaceCapture/Pro. You can connect a cable to the Aux serial input (outer RJ11 connector). Lua scripting can read/write data to that port. With the right code you can extract data and set it to virtual channels.

http://autosportlabs.net/RaceCapturePro ... unications

Let us know how it goes!