Triggerwheel made out of aluminium?

EDIS and Megajolt installation related topics. Be sure to review the <a href="http://www.autosportlabs.net/MJLJ_V4_vehicle_installation_guide">Vehicle installation guide</a>

Moderators: JeffC, rdoherty, stieg, brentp

Post Reply
knastenrad
Posts: 9
Joined: Wed Feb 09, 2005 5:33 pm

Triggerwheel made out of aluminium?

Post by knastenrad »

Would it work with a alu trigger wheel(non magnetic) or is the steel(magnetic) needed to produce the signal
?
I have considered to CNC machine a pulley with trigger wheel in one unit , made from aluminium.
If it works as a inductive sensor it would work i asume , but if it depends on the steel wheel and the coil inside the VR sensor to produce the signal ... i would not waste the time :)
Top
Oliver Sedlacek
Posts: 68
Joined: Mon Sep 13, 2004 8:45 am
Location: The Chalfonts
Contact:
Contact Oliver Sedlacek

It has to be ferrous, i.e.

Post by Oliver Sedlacek »

It has to be ferrous, i.e. steel.
Top
4600cc
Posts: 0
Joined: Sun Jul 11, 2004 1:48 am

The teeth have to be

Post by 4600cc »

The teeth have to be magnetic. I would imagine aluminum coated in something will do, or steel screws inside those teeth. I bet he has a CNC machine!!!!!!!!
Top
knastenrad
Posts: 9
Joined: Wed Feb 09, 2005 5:33 pm

Ok Thats what i

Post by knastenrad »

Ok
Thats what i suspected..
I do not have my own CNC .. but it is available :)
Top
Post Reply

Return to “Installation”