Need step by step instructions

[herbertgomez]

I have tried, to the best of my knowledge, everything to make race capture communicate with my S300. I have been unsuccessful.
Need help. I can see the S300 in my laptop; I can see race capture communicating , standalone, with the tablet.
However, we can not make race capture communicate with Hondata.
Pretty sure is a set up problem but need more knowledge and help as well but in a step by step form.

[Canyonfive]

Sure.

1) Do you have the canbus hooked up from the RCP to the s300?

2) https://www.hondata.com/help/smanager/i ... output.htm

As seen here the s300 does not have a termination resistor. You'll need one of those if you want it to communicate.

3) Post your RCP file so we can see what you did and help you.

[herbertgomez]

Thanks.
Yes, S300 Can H is hooked to RCP CanH1 and S300 CanL is hooked up to RCP Can L1.
Between both Can cables, we put a 120ohms resistor

How do I get/retreive the RCP file?

You can call me if you want- 305-336-6881

Also, RCP has instructions for RPM for our Bseries engines ECU that says to go via Pulse.

[Canyonfive]

Go to settings in your app > Then save > Go to the file explorer in your device and search for the name. > Email it to yourself, then you can post it here.

[herbertgomez]

Is this step is to install race capture in the tablet?
If so, its already installed .

[Canyonfive]

no its so me or anyone else can load your settings rather than have you post them. Its easier... Or you can post all your canbus settings and details.

[brentp]

The step-by-step instructions for Hondata is here:
https://wiki.autosportlabs.com/Hondata_KPro4

the general setup instructions are on the wiki http://wiki.autosportlabs.com.