Load Bins V3.1.0

[SRandle]

New software looking good. All seems to work OK.

One question about load bins.

After performing the TPS calibration noticed the load bins remain the same. Is this correct?

Steve.

[brentp]

Correct. *you* define the load bins- with the new TPS calibration, the load should accurately indicate 0-100%, so you need to make your load bins correspond to that range by hand. It's a one-time conversion on your part, of course.

Brent

[SRandle]

Hi Brent

Thanks for quick repley, does that mean the load bins are now 10, 20, 30...90, 100. or am I thinking in the wrong direction.

Steve.

[brentp]

They have to increase from top to bottom, but they don't have to be in multiples of 10.. they can be 10, 15, 20, 37, etc.

Also be sure check out the 3D tuning screen- you can adjust the load and RPM bins by using ALT combined with the arrow keys.

Brent

[SRandle]

Brent

Does that mean the values are in the range of 0-100. as at pressent they go to about 160 from old config.

Steve

[brentp]

yes- your load bin values should range from 0 - 100.

[SRandle]

Hi Brent

Have reloaded bins etc ok. All is sounding good on tickover.

Will report back later in week as to how car runs.

Thanks again

Steve

[SRandle]

Just to fill you in on latest developments

Car was run on rollers for first time as part of a group outing for our tiger owners club.

Car ran ok up to 5000rpm then power was down. appears our map was not too good after this so more work needed.

Thanks again for your support,

Steve.

[brentp]

Thanks for the progress update! I encourage you to share your Ignition configuration in the new Ignition map library when you feel that it's done.