another comms problem - northwest uk area help please!

danncus · Post by **danncus** » Tue Jan 24, 2006 2:05 pm

i'm having major problems with talking to my board. megajolt sofware does not see it and when using hyperteminal it does not respond to any commands. if you power the board up whilst conected to hyperterminal you get a few random characters.

does anyone live in northwest uk who can help me - i could visit with my laptop, board and hammer!

i am located south of manchester, but am willing to travel!

thanks

danny

Josh_b · Post by **Josh_b** » Tue Jan 24, 2006 3:19 pm

how far south of manchester?

MartinM · Post by **MartinM** » Tue Jan 24, 2006 3:50 pm

Send me an email (re-arrange the words com milleners hotmail at to work out where to send it) and I may be able to assist....

danncus · Post by **danncus** » Tue Jan 24, 2006 7:46 pm

hi i live in handforth 10 miles south of manchester but have transport

thanks in advance ( no pun intended!)

danny
danny at cusworth dot net

danncus · Post by **danncus** » Thu Jan 26, 2006 9:32 pm

reading the thread v2 questions, does this mean that the tuning sofware will not work on a pc running win'98.

it would be realy good to see someones setup and prove what fault i have .

can anyone help please

Brontoman · Post by **Brontoman** » Fri Sep 01, 2006 6:31 pm

Did you manage to get this sorted, I have just built mine up and the problems I have are the same. I have managed to programm the chip with the firmware but non of the programmes will communicate with the com port, and it says its not connected. I am running an 11 or 13 v supply at the moment but I dont think it is that, anyone help please?

Cheers

Andrew