Hi All,
need a bit of help, i am not sure if the pc is communicating with the MJ unit or not, when i open the program and connect up to MJ unit and obtain info from unit there is not map saved and then when i save one to it by pressing the chip type button and then go back to get that data the settings are blank again.
the car stars with the unit disconnected and runs ok but rough (due to 10 degrees)
i have read the post below on no connection to PC but i do not understand the bits on handshaking and the S and the C where do i do this, am i opening the right program ???
how can i tell if the MJ unit is actually talking to the PC or not??
thanks Grant
not sure on PC connection
Moderators: JeffC, rdoherty, stieg, brentp
-
- Posts: 58
- Joined: Mon Feb 05, 2007 9:17 pm
-
- Posts: 58
- Joined: Mon Feb 05, 2007 9:17 pm