Its Running

boostedmini · Post by **boostedmini** » Sun Apr 29, 2007 10:56 pm

HI all,

i am so happy now as my mini is now running, i have not driven it yet but should do some time this week.
I had a bit of trouble getting it going as the leads were 180 out i dont know how this can be as the sensor and wheel are setup correct but the sticker in the coil pack saying 1-4 3-2 might be wrong as the car only runs with cyl 1 at 3 on the coil pack and 4 at 2, 3 at 1 and 2 at 4. sorry if i have just confused you.

any ideas what might be wrong, i checked and it is deffinately reading the missing tooth at 90 degrees before number 1 is at TDC.

Grant

Post by **brentp** » Mon Apr 30, 2007 4:33 am

Hi Grant,

Glad to hear things are working better! What you're seeing is probably the result of reversing the leads going into the coil pack, from the EDIS module. Your engine should run just fine this way.. or if you're the pedantic type

you could flip the coil drive wires.

Let us know how it runs!

themaninthesuitcase · Post by **themaninthesuitcase** » Mon Apr 30, 2007 9:55 pm

http://www.minifinity.com/modules.php?o ... _coil_pack

We have a diagram for how they should be connected on minifinity.