Base Map On Chip?

Daryl · Post by **Daryl** » Sun Nov 07, 2004 8:49 am

I am going to fire up tomorrow and was wondering if there is a base map programmed onto the chip already?
My laptop crapped out on me so I'm without the ability to do any mapping on my own till new computer arrives.
Plan on just firing it up and see if it stays at 10 deg. or if there is a map on chip already.
Also would like to see a map for a 4 cyl pushrod N/A motor. Haven't seen any maps other than Brent's screen shot and haven't had much luck looking around the internet.
Thanks
Daryl

Daryl · Post by **Daryl** » Mon Nov 08, 2004 1:11 am

OK! There is a base map on the chip. I have added myself to the success stories. '66 Datsun.

Post by **brentp** » Mon Nov 08, 2004 5:41 am

Nice to hear that it's running!

Unfortunately, the base map that comes with the chip isn't realistic for running an engine. You should re-program it for your purposes before running your engine under high load high RPM.

Brent

Daryl · Post by **Daryl** » Mon Nov 08, 2004 6:03 pm

Thanks Brent,
I didn't think it would be good for my car, but wanted to fire it up and make sure it all worked. (It did, with no load.)
I have to wait for good weather, time off, and my laptop, before I can put it on the road so it will be a couple of weeks.